HARWI ORCA 1850, Руководство пользователя

Страница: 20 / 79

20
HORIZONTAL CUTTING
PROTECTION HORIZONTAL CUTTING
0 The machine can be equipped with a
manually operated or self-moving panel
support. It prevents damaging the plastic
strips when cutting horizontally. If the
saw-unit is adjusted on the same height
as one of the aluminium supports, the
panel support can be operated manually
or moves automatically when pushing
the saw unit forward for making the cut.
The manually operated panel support
can be re-adjusted by using the knob
(Fig. 18A).
Always cut from left to right.
Notice: If the machine is equipped with a
scoring unit which is not needed at that
moment, use the 5 mm allen key to turn it
backwards.
1 Fasten the motor carriage with the knob
at the right side at breast height.
2 Pull back the saw-unit with the handle
and hold it.
3 Pull back the blocking pin and turn the
saw-unit (Fig. 18).
4 Insert blocking pin when the saw-unit is
in its horizontal position.
5 Adjust the saw-unit at the correct height.
6 Block the carriage with the knob at the
right side.
7 Put a panel on the machine.
8 Swing the clamp of the length stop
downwards against the right side of the
panel.
9 Place the material against the aluminium
strip of the length stop.
10 Turn on the motor.
Fig. 18
Fig. 18A
11 Push the saw unit forwards.
12 Cut the material steadily from left to
right.
13 Pull back the saw unit.
14 Turn off motor.
Notice:
See to it that the riving knife is
adjusted properly (See chapter adjusting
riving knife).