HARVEY JIB MP250QM, Инструкция по эксплуатации

Страница: 6 / 39

5
3.5 Maintenance safety rules
— Do not do maintenance work until you are fully familiar with the maintenance manual.
— Always turn off the main switch and lock it before you start performing any
maintenance work. So as to avoid other people accidentally put the machine into use.
— Any maintenance of the electrical part of the equipment can be performed only by a
qualified person.
— Even if the machine is stopped, if the power supply is not disconnected, the main
switch must be turned off and locked.
— Do not clean the machine or its peripheral devices, even if the machine is completely
stopped, unless the main switch is closed and locked.
— Keep your fingers away from the belt and the belt pulley.
— Turn off the main switch and lock it when the electrical part of the device is replaced.
Failure parts can only be replaced by the products with the same specifications of the
original parts.
— Do not remove or replace the limit switch or other safety device.
— Do not start the machine before repair all remove shield, because the purpose is to
repair them to where they are installed.
— Always keep the maintenance area and work area clean.
— Any maintenance work must be performed by qualified person according to the
instructions of the manufacturer.
— Maintenance person should read the instructions manual carefully and completely.
— When replace the spare parts, must use the same parts as the standard.
— Use only the specified type of lubricating oil and grease.
— If any belt in the set of belts becomes longer than the specified limit, the whole set of
belts should be replaced.
— Do not clean the machine with compressed air.
— Responsible person should often check on the spot.
3.6 Workplace safety rules
— Always make sure that there are enough working area to operate the machine and
peripheral equipment.
— In the work area the tools and other obstacles should be put far away from the
machine.
— To ensure that the working area have sufficient lighting, no shadow or cause the
stroboscopic effect. Hygienic standard for safety and quality work are 500 times the
lowest strength.