HARVEY JIB MP250QM, Инструкция по эксплуатации

Страница: 15 / 39

14
groove will push the blade out.
— According to the rotating direction of the cutter shaft E, insert the blade into the
special slot D, pay attention to the blade angle direction should be corresponding with
the rotating direction of the cutter shaft.
— Make sure that the spring keep good working condition, press the blade lightly, let the
spring deep into the bottom of the spring hole, then rebound to the starting position.
—
Make sure the blade on the cutter shaft E is relative.
— Use the special wrench C to tighten the locking bolt, and increase pressure to the
cutter adjuster.
Check whether the knife press bar in the cutter adjuster is fixed on the cutter
shaft stably.
It is recommended that the blade run out of the cutter body extends 0.7 to
0.8mm.
Use the same method to install other blades. After finishing the blades installation
operation, assemble the machine.
7.6.1 Cutter shaft with three straight blades
— Insert the blade E into the special hole A on
the cutter shaft F.
— Check whether the blade E is symmetrical
on the cutter shaft F.
— Lock the blade, and start the planer
operation device.
— Take a piece of hard wood, plane a few
minutes from beginning to the end, in
order to lock the knife press bar better.
— To remove the blade, first loosen the knife press screw, then hit the knife press bar,
and then extract the blade out.
The manufacturer recommends that the blade extends from 0.7 to 0.8mm
8 Maintain
Always cut off the main power supply of the machine before starting the
maintenance and repair work. Turn off switch and lock the main switch!
It is necessary to always keep the V type belt of the machine in a tight state.
The machine should be cleaned on time and the handle, pin, shaft and other parts
easy to be corroded shall be properly lubricated. The time interval of these activities