Harvest TEC 602A, Руководство по установке

Страница: 21 / 24

21
Optional iPad Display Kit (030-4670DK)
Ref Description Part # Qty Ref Description Part # Qty
1 Suction cup mount 001-2012SCM 1 7 iPad Mini Charger 12V 001-2012P 1
2 Ram mount 001-2012H 1 8 iPad Mini 4 case 001-2012C4 1
3
iPad Mini spring load
cradle (Mini 4)
001-2012SLC 1 9 iPad Mini 4 006-4670IP 1
4 16 gauge power wire 006-4723P 1 NP 4 amp fuse Hardware 1
5 Female spade connector Hardware 2
6 Eye loop connector Hardware 2 Mounting Kit Assembly 030-4670DK
(Includes All Parts)
Installation Instructions
1. Identify 12V power source for wires to connect.
a. Eye loops included if wiring directly to the battery is desired.
b. Test for key power source if preferred to have power to the USB shut off with the key.
2. Once power source is identified, cut wires to desired length.
3. Crimp the two supplied quick connectors onto the white and black wire.
4. Remove the round locking plastic nut from USB plug before connecting the wires. Black (+) White (-).
5. The wires will then be hooked to the designated terminals on the bottom of the USB plug
6.
Drill a 1 1/8” hole in the preferred mounting location. Be sure to clean any sharp edges after drilling.
7. Feed the wires through the mounting hole.
8. If using the round plastic nut to secure plug in place, slide the nut back over the wiring before connecting
the wires to powered source.
9. Connect the wires to the identified power source if easier to do so before tightening the plug into place.
10. Tighten plug using either the round plastic nut or mounting plate and two screws, both options supplied.
11. Once connected, hook a USB charging cord into the plug and connect a mobile device/tablet to ensure the
plug is operating as you wish (key power working properly if necessary).
NOTE: This plug is not designed to charge two iPads. System damage could occur if this is attempted.
System will charge a mobile phone and iPad simultaneously without problem.
7
1
2
3
4 5
8
6
9