Harrie Leenders FUGA eL, Руководство пользователя

Страница: 20 / 34

36 37
2b. Installing wall plate for stove with rear outlet
• Determine the centre of the wall plate at 114 cm above the
floor.
• Fix the wall plate with connection ring using plugs and
chipboard screws.
• Fill up gap, if any, between wall and wall plate if necessary
in order to ensure the wall plate is plumb.
• Mark off the centre of the stove on the floor (standard distance
from wall is 37 cm).
5. Rotatable base
• Fixed position: leave the stove as delivered.
• 2x30° (rear outlet) or 2x60° (top outlet) rotatable: slacken bolt
no. 2. Slightly loosen bolts no. 1 and secure them with the nut
(socket-head wrench 4 mm, open-end spanner j.w. 13).
• Check to ensure bolts no. 1 have not been loosened too much.
• 360° rotatable (possible for top-connected stove pipe only):
remove all bolts.
4. Placing the door
• Carefully hang the door back on its hinges.
Be careful not to cause any damage.
3. Positioning the stove
• Push the stove in the marked position using the sliding pieces.
Be careful not to damage the floor.
• Remove the sliding pieces.
• Remove the packaging.
6. Levelling
• Tilt the stove to gain access to the four adjusting feet.
• Turn the adjusting feet to level the stove.
• Make sure that all of the adjusting feet touch the floor in order
to ensure the stove’s stability.
• Push the edge rubber down to avoid leaving a slit.
7b. Fixing the clamping strip for stove with top outlet
• Fit the clamping strip around the outlet stub.
• Tighten both screws at the back.
• Cover the screws with the finishing cap.
7a. Installing duct material on top outlet
• Make the stove pipe to size.
• Push the stove pipe on pipe of ceiling plate.
• Pull the sliding pipe down to the stove.
Top outlet Top outlet