How to Configure and Monitor the ProView 7000
© 2010 Harmonic Inc.
5
ProView 7000, v.2.3, Rev. A
iii Right-click the device icon in the Device box and select
Connect
in the device context
menu.
If the ping fails and the device fails to connect, check your network connections and
settings.
iv Click
Device Explorer
in the EMS toolbar to display input and output stream trees.
How to Configure and Monitor the ProView 7000
You can configure and monitor the ProView 7000 with either the front panel or over an IP
network using the ProView 7000 EMS.
■
Configuring the ProView 7000 using the Front Panel
■
Monitoring the ProView 7000 using the Front Panel
■
Configuring the ProView 7000 using EMS
■
Monitoring the ProView 7000 using EMS
Configuring the ProView 7000 using the Front Panel
The ProView 7000 has four logical multiplexes. A license is required for using more than one
multiplex.
To configure the ProView 7000 via the Front Panel:
1. If the input stream is received from a satellite, navigate
Root > 1 Reception > 1 Configuration
and configure the receiver parameters according to
your satellite parameters.
2. If you wish to use GbE output:
i
Navigate
Root > 4 GbE > 1 GbE Port (1 or 2) > IP Configuration.
ii
Configure the IP Address, Subnet Mask and Default Gateway.
iii Select
4 Apply Port Changes
.
iv Select
1 Apply Changes
.
v
Navigate
Root > 4 GbE > 1 GbE Port (1 or 2) > 3 Admin Status
.
vi Set the Admin Status to
Up
.
vii Navigate
Root > 4 GbE > 3 Socket Configuration > 1 Socket Out > 1 Socket (1,2,3 or 4)
.
viii Configure the Destination IP Address and the Destination UDP Port.
ix Set the Socket Status to
Up
.
3. If you wish to descramble, you must associate the CAM to the multiplex:
i
Navigate
Root > 6 CAM > CAM (1 or 2) > 1 CAM Association
.
ii
Select a multiplex, TS1, TS2, TS3 or TS4.
The descrambling mode default is
Selective
, you can change the mode to
Full
.
4. To access the CAM MMI menu, select CAM MMI.
5. Select an input port:
i
Navigate
Root > 3 Routing and Descrambling > 1 TS (1,2,3 or 4) > 2 Input Selection
.
ii
Select an input port for the received transport stream (Options: SAT 1, ASI 1, ASI 2
and ASI 3).
