Harmonic Drive SC-610 Series, Руководство по эксплуатации

Страница: 28 / 69

Operations Manual SC-610 Page 25
Harmonic Drive AG 900105 11/2005
Control Input Wiring:
4.2.2 Control Outputs
The control outputs must be supplied with an external voltage. The wiring of the control outputs is optional
and not necessary for proper drive operation.
Control Output Function:
Signal name Connector Switch Position / Function
Pin active / closed not active / open
FAULT+
FAULT - X3.4
X3.5 Controller happy - no fault Controller not happy - drive
fault
DOUT 0 X3.18 Digital output 0 = logical 1 Digital output 0 = logical 0
DOUT 1 X3.19 Digital output 1 = logical 1 Digital output 1 = logical 0
DOUT 2,
DrOK
X3.20 Digital output 2 = active - no
fault Digital output 2 not active =
drive fault
More about control outputs:
"FAULT": This output is a relay contact and consists of two connector pins. It indicates the general
drive status.
The FAULT relay contact is not suitable for switching inductive
loads (relays). Inductive loads can cause some nuisance drive
faults.
"DrOK": This output has the same functionality than the fault relay output. The output (+24V) is
activated in case the drive is ready for work.
"DOUT x": These outputs can be used together with the drive internal PLC program. There are 2 digital
outputs available.