Harman The Serenity III HB 38 DV, Инструкция по установке и эксплуатации

Страница: 8 / 54

8
OPERATION
15. Set the High-Low Regulator to the desired setting:
Turn fully counterclockwise for High and fully
clockwise for Low.
16. Press the rear burner switch to the “ON” or “OFF”
position as desired. This switch will return to the
center position after it is pressed. This is normal as
well as a faint click when pressed. The main burner
must be lit before the rear burner will light. The rear
burner may be turned “ON” or “OFF” at any time.
NOTE:
An odor, resulting from the initial heating of
new materials in your heater, is not unusual during the
first fire, and in most cases will disappear after an hour
or two.
HOW TO TURN OFF THE FIRE
1. If using the optional thermostat, set thermostat to the
lowest position.
2. Turn off the electric power to the appliance.
3. Turn the ON-OFF/THERMOSTAT switch to the
OFF position.
4. Push in the gas control knob slightly and turn it
clockwise to “OFF.”
NOTE:
The knob cannot be turned from “PILOT” to
“OFF” unless it is pushed in slightly. Do not force it.
FLAME HEIGHT ADJUSTMENT
There are separate adjusters for the front and rear
burners. These adjusters can be accessed by reaching
to the left side of the control panel and toward the back
of the unit. Turn the adjusters counterclockwise (up) to
increase flame height and clockwise (down) to decrease.
See above left. Adjusting the flames too high will cause
them to have black tips and cause sooting. Sooting can
cause the glass to get dirty.
Warning: The unit and adjuster may be hot. Wear
gloves and arm protection if making adjustments
while in operation.
Pilot Flames
If pilot flames are less than shown at left, use pilot
adjuster to increase flames.
Rear Burner
Adjuster
Front Burner
Adjuster
Bottom rear view of burner module.
Normal Flame pattern. Note: Flames will vary in height
and position depending on the placement and the amount of
ember wool.