Harman Soundcraft Si impact, Руководство пользователя

Страница: 44 / 132

User Manual
6.1.1: INPUT SETUP
CHANNELS & BUSSES > INPUT CHANNELS > SETUP
6.1.1: CHANNELS & BUSSES > INPUT CHANNELS > INPUT SETUP
MIX 1-14 Pre/Post
Set individual Pre- or Post-Fade routing to Mix Busses 1-14.
Choose from Post Fader, Post EQ, or Pre Dyn.
DirectOut Pre/Post
Choose whether the Direct Output patch is sourced Pre Filter or Post Filter.
Post Filter is immediately after the HPF (High Pass Filter) but before the main EQ and Dynamics processing stages.
Pre Filter is immediately after the Analogue To Digital conversion, before the Trim, Phase, and Delay stages. There
must be a patched DirectOut for this option to be functional.
LCR Pan Width
Set the proportion of centre channel signal sent to Left And RIght.
Adjust the pan law when in LCR mode is active to increase/decrease the contributions to the LR and Mono buses
when panning.
DirectOut Patch
Choose an analogue or digital output for this channel's Direct Output.
Touching the value field will bring up the standard Patching setup on the Touch Screen. For more detail, please see
section 5 - Inputs & Outputs.
Input Patch
Choose an analogue or digital input for this input channel.
Touching the value field will bring up the standard Patching setup on the Touch Screen. For more detail, please see
section 5 - Inputs & Outputs.
Set Global Post/Pre
Set a global routing for all Mix bus contributions from the input channel.
You can choose from all three bus ‘taps’: All Post Fader, All Post EQ, or All Pre Dyn. Alternatively, the Pre- or
Post-fader routing can be set individually for the each Mix Bus contribution further down the menu. This setting can
be overridden by the Output Bus setup.