Harman Martin ELP PAR, Руководство пользователя, Страница: 15 / 52

Martin ® ELP PAR User Guide 15
Connecting to AC power
Read ‘ Safety information ’ on page 4 before connecting the
fixture to AC mains power.
Before you connect other fixtures to the POWER OUT socket,
see ‘ Linking fixtures to power in a chain ’ on page 16.
For protection from electric shock, the fixture must be
grounded (earthed). The power distribution circuit must be
equipped with a fuse or circuit breaker and ground-fault (earth-
fault) protection.
Socket outlets or external power switches used to supply the
fixture with power must be located near the fixture and easily
accessible so that the fixture can easily be disconnected from
power.
Do not use an external dimming system to supply power to the fixture, as
this may cause damage to the fixture that is not covered by the product
warranty.
The fixture requires a power input cable with a Neutrik powerCON TRUE1
NAC3FX-W (TOP) female cable connector for AC mains power input. The
cable must meet the requirements listed under “ Protection from electric
shock ” on page 5. Martin can supply suitable cables with female TRUE1
TOP input connectors 1.5 m (4.9 ft.) or 5 m (16.4 ft.) long, as well as loose
female TRUE1 TOP
input connectors (see “ Accessories ” on page 46).
The fixture can be hard-wired to a building electrical installation if you want
to install it permanently, or a power plug that is suitable for the local power
outlets can be installed on the power cable. If you install a power plug on the
power cable, follow the plug manufacturer’s instructions and connect the
wires in the power cable as shown in this table:
Earth , Ground or Neutral or N Live or L
US system Green White Black
EU system Yellow/green Blue Brown
The fixture has an auto-ranging power supply that accepts AC mains power
at 100-120/200-240 V at 50/60 Hz. Do not apply AC mains power at any
other voltage or frequency to the fixture.