Harman dbx ZonePRO 1260, Руководство по установке

Страница: 27 / 56

25
ZonePRO
TM
Section 6 - Networking
6.1 Default ZonePRO Network Settings
The below table shows the factory default Internet Protocol (IP) settings and ZonePRO
Designer Node IDs for the ZonePRO series products.
640, 641 1260, 1261 640m, 641m 1260m, 1261m
IP Address
N/A 169.254.2.2 169.254.XXX.XXX 169.254.XXX.XXX
Subnet Mask
N/A 255.255.0.0 255.255.0.0 255.255.0.0
Gateway
N/A 0.0.0.0 0.0.0.0 0.0.0.0
ZPD Node ID
48 32 Dynamic Dynamic
The ZonePROm processors derive their Node ID and the last two octets of their IP address
from the processor’s Mac address. This helps prevent IP address and Node ID conflicts when
networking multiple ZonePROm processors. The ZonePRO 1260 and 1261 have a static IP
address as shown in the above table. Therefore, when networking multiple ZonePRO 1260s or
1261s, their IP addresses must be changed manually in order to avoid IP conflicts.
6.2 Networking Overview
This section provides a step-by-step guide on how to properly connect and configure LAN
settings for three different network architectures. The first topology is a simple direct
connection using an Ethernet crossover cable. The second method describes how to connect
several ZonePROs to an isolated network and configure them with the ZonePRO Designer GUI.
The final configuration details how to add one or more ZonePRO devices to an existing Local
Area Network (LAN). The following subsections explain how and when to connect to a remote
ZonePRO using the proxy feature and some tips and examples of how to access your ZonePRO
by setting up a Virtual Private Network (VPN). This section concludes with some further
networking considerations and troubleshooting tips that will help with connecting to your
ZonePRO device via Ethernet.
Careful planning should be made before placing a ZonePRO on a network that provides any
access to the public. Some examples of public access are direct access to the device from
the Internet, an unsecured or weakly secured wireless network, a network jack in a public
area that provides network access to the ZonePRO, or having a computer on the LAN that is
not secured so that someone could use the ZonePRO Designer software to reconfigure the
ZonePRO. It is highly recommended that the equipment be placed on a protected, isolated
network that does not have any connection to the public to prevent unauthorized users from
reconfiguring the device. Please refer to the VPN portion of this section for more information.
At the current time, ZonePROs do not support DHCP or Auto IP (see the previous “Default
ZonePRO Network Settings” section for more information). In order to use Ethernet to manage
the device from the ZonePRO Designer GUI, modifications to the network settings may be
Section 6
Networking