10
HOW TO USE THE POP-UP DIGITAL DISPLAY
The display panel can be exposed by firmly pressing the
button located in front of the display panel. The display
panel will open and rotate upwards.
DO NOT CLOSE POP-UP DIGITAL CONTROL PANEL UNDER
ANY CIRCUMSTANCES DURING OPERATION OF SMOKER.
Control Panel Operating Instructions
Setting the Temperature:
• Push ON button.
• Push TEMP button; LED display will blink.
• Set the temperature by using
and
.
• Push TEMP again to set the preferred temperature.
Note
: Heating will not begin until the timer is set.
Setting the Timer:
• Push TIME button; LED display for hours will blink.
• Set the hours by using
and
.
• Set the minutes by using
and
.
• Push TIME again for timer to begin.
HEATING WILL START AT THIS TIME. HEAT WILL TURN OFF WHEN TIME HAS EXPIRED.
Resetting the Control Panel:
If control panel shows an error message, turn electric smoker off by:
•
Holding the ON / OFF button down until the display goes blank.
•
Turn off the power point
•
Unplug unit from the power point
•
Wait ten seconds, plug unit back into the power point
•
Turn back on at the power point
•
Then turn electric smoker on
This will reset the control panel.
4.0
4.1