Hardy H3, Инструкция по установке и эксплуатации

Страница: 16 / 46

HARDY MANUFACTURING CO., INC (MODEL H3, H5, & H6) PAGE 6
Section II 2-2 Hull Removal
After placing your new Hardy Heater upon the concrete pad, you are ready to continue the
installation process. There are two methods to gain access to the rear of the Heater to
make plumbing and electrical connections.
The first and easiest method is to remove the screw holding the back door panel in place.
The door is easily removed by lifting up on the handle and taking it out. With the back door
removed, using a 5/16” wrench, remove the 8 metal screws that are located below the
back door. There are four on each side that hold the panel in place. After the crews are
removed, the panel should come out easily and allow access to the bottom of the unit to
make plumbing and electrical connections.
The second method is the removal of the entire cover. With the back and the rectangular
piece of stainless and insulation between the fire box and ash door removed, the outside
cover can be lifted up and off as seen in the picture. To replace the cover simply repeat
these steps in reverse order.
Rear View
Front View