Hardy H3, Инструкция по установке и эксплуатации

Страница: 37 / 46

HARDY MANUFACTURING CO., INC (MODEL H3, H5, & H6) PAGE 27
Section VI 6-5 Improper Burning
If the fire is not burning properly, remove all of the ashes and wood from the heater. Check to
see if the grates are stopped up. Check the air intake at the back of the heater to insure it is
clear of ashes. Lift the damper lid to check for ashes. Check to see if the force air blower is
running. If you have made these checks and the fire will not burn properly, remove the
smokestack and check for creosote buildup. Look down the smoke stack into the firebox to
check for creosote buildup. On the 180,00 BTU heater there is a removable baffle in the
firebox just below the smokestack. Remove this baffle through the firebox door. Clean off the
creosote and reinstall the baffle. These steps should correct the problem. If the fire goes out
when the damper is closed and will not start (After the damper has been open for at least 15
minutes), remove one of the screws in the damper lid. If the problem continues, remove the
other screw. (Remove the screws only if you are absolutely sure the fire is going out !!!)
6-1 Ash Removal
Ashes must be removed before they build up to the level of the grates. Failure to keep the
ash bin cleaned out will result in warped grates. The buildup of ashes in the firebox should be
checked at least once a week. Allow the fire to burn down until the grates can be seen. This
insures that all of the grates are clear. Failure to do this will cause your heating system to
stop working and the grates to warp. If the grates warp slightly, they can be turned over and
allowed to straighten out. The drawing shown below shows how the grates should look when
you allow the fire to burn down.
When cleaning grates,
do not remove ash build
up on sides of fire box
Allow fire to burn
down and insure all
grates are clear at
least once a week
Do not allow ashes to
build and touch grates
and when removing
ashes leave at least
1/2” - 1” of ashes in
bottom of ash pan