Hardt Inferno GC, Руководство по эксплуатации

Страница: 17 / 18

HARDT
Responsive, Reliable Solutions
CUS-013-0025-02 Page 17 of 19
6. Troubleshooting
DISCONNECT POWER TO THE ROTISSERIE BEFORE ANY MAINTENANCE, SERVICE OR CLEANING
IS PERFORMED.
ROTISSERIES EQUIPPED WITH CASTERS ARE SECURED IN PLACE USING A RESTRAINING CABLE
LOCATED ON THE RIGHT REAR UNDERSIDE OF THE ROTISSERIE. THIS CABLE MUST BE
DISCONNECTED PRIOR TO REMOVING THE ROTISSERIE AND CAUTION MUST BE TAKEN TO
ENSURE IT IS CONNECTED ONCE THE ROTISSERIE HAS BEEN RETURNED TO ITS ORIGINAL
POSITION.
THE ROTISSERIE IS HOT WHEN OPERATING. EXERCISE CAUTION WHEN WORKING NEAR THE HOT
ROTISSERIE.
WEAR APPROPRIATE PROTECTIVE CLOTHING.
Rotisserie Does Not Operate
The rotisserie does not operate when the red main ON/OFF is pulled out (i.e. drive does not turn, and no lights in
cavity).
SOLUTION:

Verify that the door is fully closed. The magnetic door switch disables or enables the ignition system.

Check rotisserie electrical power: If the rotisserie's lights are off, check the circuit breaker on the back of
the unit as shown in Figure 3-1 and Figure 3-2
. If the circuit breaker is ‘OFF’ (tripped), return to 'ON'.

If this circuit breaker is ‘ON’, ensure that the power cord is plugged into the wall and that there is power
coming from the socket. If power is available and the rotisserie still does not operate, contact your local
authorized service partner.
Safety Lockout
If the red main ON/OFF switch is pulled out, the drive drum will rotate and the igniter will attempt to light the burner.
If there is no flame after six minutes, the rotisserie will go into 'SAFETY LOCKOUT'. Push the red main ON/OFF
switch in to turn the rotisserie off.
Possible causes include: the gas supply is shut off, the flame sensor is not sensing flame or there is some
component failure.
SOLUTION:

If the
rotisserie goes into ‘safety lockout’ again. Turn
the rotisserie off (push in main ON/OFF switch).

Verify that the gas supply to the rotisserie and the main
gas valve are both open. Try starting the unit again by
pulling the red main ON/OFF switch out.

If
the rotisserie goes into ‘safety lockout’ again, turn the
rotisserie off.

When you are certain the rotisserie interior is cool to
the touch, gently lift the flame sensor and burner
covers out of the unit. See Figure 6-1.
(continued on following page)
Figure 6-1
Flame Sensor Cover
Burner Cover