Hardt Inferno GC, Руководство по эксплуатации

Страница: 18 / 18

HARDT
Responsive, Reliable Solutions
Page 18 of 18 CUS-013-0025-02

Using a soft towel, gently wipe the top of the burner
and carefully clean the flame sensor. See Figure 6-2.

Try starting the rotisserie again by pulling out the main
ON/OFF switch.

If the rotisserie goes into safety lockout again there is
most likely a component failure. Turn the rotisserie off
and contact your local authorized Hardt service
provider.
Figure 6-2
Replacing the Halogen Lamp
1. Turn rotisserie off (push in main ON/OFF switch) and
disconnect the power cord from the wall receptacle.
2. Allow rotisserie to cool down.
3. Remove the light access panel located on the left side of
the rotisserie by loosening the thumb screws (by hand or
using a screwdriver) (Figure 6-3).
4. Loosen the wing nuts on the light support bracket in order
to access the light (Figure 6-4).
5. While wearing gloves, gently pull the light bulb out of its
fixture (Figure 6-5).
Figure 6-3
Figure 6-4
Figure 6-5
Do not touch the replacement bulb with bare fingers
or dirty gloves.
6. Install a new bulb.
7. Position bracket so that the light is oriented towards the
center shaft of the rotisserie. Hand tighten the two wing
nuts.
8. Reinstall access panel.
9. Plug the power cord back into the wall receptacle.
10. Turn the rotisserie on (pull out main ON/OFF switch).
11. Verify that the replaced bulbs function correctly (it is
normal for the lights to take about 6 seconds to light after
the main switch is pulled ON). If not, repeat the first four
steps of this procedure and make sure the bulb was
correctly inserted in the socket. Reinstall the access
panel, turn the rotisserie ON and recheck. If problems
persist, contact your local authorized service partner.
Flame Sensor
Burner
Remove