Hardi NAVIGATOR EAGLE 3000, Инструкция

Страница: 149 / 178

6 - Maintenance
149
Wear Bushing Replacement on ParaLift
Inspect and renew the wear bushes before they worn through.
1.
Connect the trailer to a tractor and unfold the boom to working
position.
2.
Lift the boom centre frame with a lifting device and support it,
until the load relieved from the parallelogram arms.
3.
Remove the screw (A), and pull out the pin (B) at one of the upper
parallelogram arms.
4.
Replace the wear bushes.
5.
Refit the arm.
6.
Repeat this on the other upper arm.
7.
Disconnect the lower arms simultaneously, when changing wear bushes here.
8.
Apply grease into all grease nipples.
9.
Remove the lifting gear again.
Suspension Rubber Dampers
Replace the rubber dampers if they loose their efficiency.
1.
Connect the sprayer to a tractor to prevent overbalancing.
2.
Lift the rear end of the sprayer with e.g. a crane. Use lifting points as described in “Sprayer setup”.
3.
Loosen the nut below the suspension rubber dampers.
4.
Remove the suspension rubber dampers and replace with new ones.
5.
Tighten the nut below the suspension rubber dampers.
6.
Lower the rear of the sprayer again.
Replacement of the Transmission Shaft Shield
•
See the manufacturer’s instruction book.
Replacement of Transmission Shaft Cross Journals
•
See the manufacturer’s instruction book.
Light Bulb Change
1.
Switch off the light.
2.
Loosen the screws on the lamp and remove the cover or lens.
3.
Remove the bulb.
4.
Fit a new bulb, refit the cover and tighten the screws.
μ
ATTENTION! If halogen bulbs are used, never touch the bulb with your fingers. Natural moisture in the skin will cause
the bulb to burn out, when the light is switched on. Always use a clean cloth or tissue when handling halogen bulbs.