Hardi NAVIGATOR EAGLE 3000, Инструкция

Страница: 109 / 178

5 - Operation
109
Use of RinseTank and Rinsing Nozzles
The integrated RinseTank can be used for two different purposes.
μ
ATTENTION! If a cleaning procedure is given on the chemical label, follow it closely.
In-Field Diluting Before Cleaning
In-field diluting of remaining spray liquid residue in the spraying circuit should be carried out, before cleaning the sprayer.
Rinsing the MainTank and liquid system:
1.
Empty the sprayer as much as possible. Close the AgitationValve (no agitation) and spray until air comes out of all
nozzles.
2.
Turn the suction SmartValve towards and the pressure SmartValve towards .
3.
Engage the pump. Set the pump speed to approximately 300 RPM.
4.
When 1/3 of the contents in the RinseTank is used, turn the suction SmartValve towards and operate all valves on
the pressure side of the system in the following order, so that all hoses and components are rinsed:
A.
Turn the pressure SmartValve towards to activate the ejector and open the TurboFiller suction valve.
B.
Open the TurboDeflector valve and close it again, when clean water comes out of nozzles.
C.
Close the TurboFiller lid and press the Chemical Container Cleaning lever in approximately 5 seconds to clean
this device.
D.
Open the TurboFiller lid again, and make sure that the TurboFiller is empty.
E.
When empty, close the TurboFiller suction valve again. Ensure that the External fast filling connection and the
line are not contaminated with chemicals.
5.
Turn the suction SmartValve towards and the pressure SmartValve towards , and spray the liquid out in the
field just sprayed.
Cleaning of MainTank:
6.
Turn the suction SmartValve towards and the pressure SmartValve towards . Remove the filling strainer to
avoid any cleaning shadows behind it.
7.
When another 1/3 of the contents in the RinseTank is used, turn the suction SmartValve towards .
8.
Turn the pressure SmartValve towards , and spray the liquid out in the field just sprayed.
9.
Repeat step 6 - 8 one more time.
±
WARNING! When critical chemicals (like sulphonylurea) have been used, or a cleaning detergent is recommended, do
an extra cleaning:
10.
Fill the RinseTank again.
11.
Fill the MainTank with 500 litres of clean water.
12.
Add the cleaning detergent to the MainTank by using the TurboFiller. Follow instructions on the label of the cleaning
agent.
13.
Clean the whole system again.
14.
To get the best cleaning effect, the CycloneFilter and the suction EasyCleanFilter sieves should be washed with clean
water.
15.
Rinse the sprayer with clean water afterwards.
μ
ATTENTION! The rinsing nozzles cannot always guarantee a 100% cleaning of the tank. Always clean manually with a
brush afterwards, especially if crops, which are sensitive to the chemical just sprayed, are to be sprayed afterwards!