Hardi HC 9600, Руководство оператора

Страница: 96 / 212

4 - System setup
94
Serial GPS Settings
÷
NOTE! Default settings for the 6000/6500 receivers should not need to be adjusted from factory settings.
• Differential Source
Select choice of:
• GLIDE
• WAAS/EGNOS
• TerraStar®
• RTK External
• RTK.
Options available are based on receiver type
and unlocks.
• Wrench icon
Pressing the Differential Source Wrench
button opens different settings screens,
depending on the differential source
selected.
• Age of Differential
Displays the elapsed time since reception of last differential correction signal. The Age of Differential button is only
functional when GPS is connected.
• StableLoc checkbox
StableLoc maintains accurate steering – even when your correction signal is temporarily lost – by seamlessly
transitioning to the next available signal source. When the signal is restored, the system will then transition back to the
higher accuracy source, eliminating position jumps.
Press to enable.
• StableLoc Error Limit (RTK & TerraStar only)
When using StableLoc, select the error limit at which the system will no longer allow steering.
• or – button to adjust the limit.
If your error limit is “4 in” and the system accuracy reaches that limit, steering will no longer be allowed until the error
decreases. If set to “none” accuracy of the differential source will not affect the ability to autosteer.
• Reset to Defaults
Press the Reset to Defaults button to restore receiver settings to the factory default. This will remove all custom settings.
• NMEA Talker
This button disables the GLONASS prefix in the NMEA messages. If using the GPS receiver with legacy displays or a
device that does not support GLONASS messages, uncheck the box.
Receiver: GPS 6500
Serial General
GPS Settings
Differential Source
Features
StableLoc
NMEA Talker
Age of Differential
Upgrade
Firmware
General
Reset to
Defaults
Port A (Connected) Port B
None