Hard Head 022279, Руководство по эксплуатации

Страница: 26 / 52

26
4.3 To load the product
1
Lower the forks to the lowest position.
2
Put the forks under the load or the pallet.
3
Put the lever in position C.
4
Pump the steer handle up and down until the forks
have reached the required height.
4.4 To move the product
1
Put the lever in position B.
2
Push or pull the load to the required place.
4.5 To lower the product
1
To lower the forks, put the lever in position A.
2
Pull out the forks from the load.
5 Maintenance
● Do a check of the product for wear at regular intervals.
● Replace damaged or worn parts before the product is
used again. Have your products serviced by a qualified
repair person using only identical replacement parts. This
will ensure that the safety of theproduct is maintained.
● Lubricate moving parts.
● Do a regular check of the jack screw, lubricate if
necessary.
5.1 To adjust the valve pressure
Put the lifting/lowering lever in position B. Adjust the valve
pressure by pumping the foot pedal. If the valve need to be
adjusted follow the instruction below:
1
Pump the handle a few times to raise the forks.
2
Loosen the nut on the adjusting screw under the foot
pedal.
3
Use a flat screw driver to tighten or loosen the
adjustment bolt.
4
Make a test run and then tighten the nut again after
the pressure has been adjusted.
5
Put down the steer handle and pull the chain through
the hole on the steer handle pin above the pump
piston. (Figure 6)
6
Screw the bolt for the chain on the foot pedal and
tighten the nuts. (Figure 7)
7
Lock the handle pin, tap the spring pin using a
hammer on both sides. (Figure 8)
4 Operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Warning! The product is intended to be used by
persons with technical knowledge and experience of the
type of products described in the instructions.
● Read the instructions carefully. Be familiar with the
controls and the correct use of the machine. If you lack
such knowledge and experience you should get trained
from persons who have such knowledge and experience.
4.1 To do before you operate the
product
● Do a check of the product before use and make sure that
it operates correctly.
● If the product has damaged or do not operate correctly,
contact an authorized service center for inspection and/
or repair.
● Do a check and make sure that the product has the
correct level of hydraulic fluid.
● Examine the product and make sure there are no leaks.
Warning! Hydraulic fluid and other fluid that leaks un-
der high pressure can penetrate the skin and cause serious
personal injury. Seek medical attention immediately if fluid
penetrates the skin.
● Do a check and make sure that the lowering valve is
closed before you lift a load.
Caution! Do a check to ensure that the load on the
forks is correctly and safely positioned.
4.2 Release/ Position lever
Figure 10
A. To lower the forks.
B. Neutral position, the steer handle moves freely.
C. To lift the forks.