Hanwha Techwin Wisenet SPD-152, Руководство пользователя

Страница: 64 / 66

64_
appendix
appendix
appendix
USINg VIRTUAl KEybOARD
1. For alphanumeric inputs, the virtual keyboard window appears.
2.
Using a mouse, click on the desired character tab.
3. Select < Ok >.
Entered words are applied.
￭
If you want to enter the upper case and special characters, select < Caps lock > or < Shift >.
￭
Using the virtual keyboard is the same to a normal keyboard use in your region.
￭
Your ID can contain any combination of upper and lowercase alphabets and numbers.
￭
If the password length is 8 to 9 digits, you can combine at least three different types of the following characters: upper and lowercase alphabets, numbers,
and special characters.
￭
If the password length is 10 digits or more, you can combine at least two different types of the following characters: upper/lowercase alphabets, numbers,
and special characters.
TROUblEShOOTINg (fAQ)
Problem Action
Live video is slow or cut off.
●
The frame number set for multiple data transmissions that are set in a camera or network
environment could differ from the actual rate of transmission.
Click < > at the bottom of the screen to check the number of incoming frames per
channel and the actual number of frames played.
When you register a camera, the Live4NVR profile will be created by default.
If necessary, go to “
Setup > Camera > Profile setup > Edit ” and change the number of
frames.
●
If you keep seeing video slow down or cut off, then check the network environment or camera
condition.
The system does not turn on and the indicator on the front
panel does not operate at all.
●
Check if the power supply system is properly connected.
●
Check the system for the input voltage from the power source.
●
If the problem persists even after you have taken the above actions, check the power supplier
and replace it with a new one.
The video input is okay, but the videos of some channels are
not properly displayed or are abnormally displayed (e.g. black
screen, B/W screen).
●
Check if the camera is properly supplied with power.
●
Check the state of the cable connected to the camera and reconnect it after replacing or
disconnecting it.
●
Check the video output connecting the camera's Web Viewer.
●
Check if the network port is properly connected and the network setting is set correctly.
●
Changing the hub connected to the network to the one supporting Gigabit may solve this.
The screen keeps displaying the logo image.
●
This may occur from a problem with the main board, or the related software being corrupt.
Contact the nearest service center for more information.
The screen of the connected monitor is not displayed or
displayed abnormally.
●
Check if the necessary cables are connected to the monitor properly.
●
Some monitors do not support the decoder output (HDMI1 or HDMI2). Check the monitor
resolution.
– HDMI1 : 3840x2160(30 Hz), 1080P, 720P, 1280x1024
– HDMI2 : 1920x1080, 1280x720, 1280x1024, 1024x768
●
Remove the monitor cable connected to the decoder and connect again.
No response controlling PTZ in the live screen.
●
Check if the registered Camera supports the PTZ function.
The camera is not connected or the PC fails to connect to the
product.
●
Check if the network cable is connected properly.
●
Ensure that you have set Network - Connection Mode.
●
Check the IP setting of the PC or camera.
●
Try the Ping Test.
●
Check if there is a different device near the product that uses the same IP.
The input camera image is too bright or too dark.
●
Check the registered camera settings in “
Setup
>
Camera
>
Camera setup
”.