Page GB-12
Cooking zones and sensors
Press the ‘
-
‘ sensor (11) (multiple times in a
row if necessary) or press and hold it down
with your finger longer to decrease the heat
setting of the selected cooking zone (‘1’ = is
the lowest heat setting; ‘0’ = indicates no
heating).
After a few seconds, the number beside
the selected cooking zone lights up nor-
mally and cooking can begin on the select-
ed cooking zone.
5
If you do not press a sensor or do not
place suitable cookware on the cooking zone
within one minute of switching the hob on, the
hob will switch off automatically.
You cannot activate the ‘
+
’- and ‘
-
’ sen-
sors with normally illuminated indicators
before you have selected a cooking zone.
If there is no pot, or no suitable pot,
placed on the selected cooking zone,
the ‘ ’ indicator will appear beside the
corresponding sensor after approximately
two seconds. As soon as you place a suitable
pot on the cooking zone, the selected heat
setting will again be displayed.
In rare cases, this indicator may also appear
when there is a suitable pot. After a few sec-
onds, however, the selected heat setting will
be displayed again.
Increasing or reducing the
heat setting of a cooking zone
Even if the cooking process has already be-
gun, you can increase or decrease the heat
setting of a cooking zone.
1. Press the sensor for the required cooking
zone.
The indicator beside the cooking zone will
blink.
2. Press the ‘
+
’ sensor (10) (multiple times
in a row if necessary) or press and hold it
down with your finger longer to increase
the heat setting of the cooking zone.
Press the ‘
-
’ sensor (11) (multiple times in a
row if necessary) or press and hold it down
with your finger longer to reduce the heat
setting of the cooking zone.
After a few seconds, the indicator for the
selected cooking zone will be normally lit
and the new heat setting will have been
selected.
When the ‘ ’ indicator and not the heat set-
ting is blinking in the display, this may have
the following causes:
– The cookware is not placed on the cor-
rect cooking zone.
– The cookware being used is not suitable
for induction hobs.
– The cookware is too small or is not cen-
tred on the cooking zone.
As long as there is no suitable cookware on
the cooking zone that is switched on, no heat-
ing will occur.
Switching off individual
cooking zones
1. Use the sensor field (5) to select the ac-
tive cooking zone.
2. Press the ‘
-
’ sensor (11) (multiple times
in a row if necessary) or simultaneously
press the ‘
+
’ (10) and ‘
-
’ sensors until the
heat setting ‘
0
’ indicator is displayed
