Hansa C65RX, Руководство по эксплуатации, техническому обслуживанию и безопасности

Страница: 33 / 42

Hansa C65RX O&M Manual – OM-029 First Release 4/05/2021
© Hansa Chippers 2021
31
Maintenance & service intervals
Maintenance interval - service hours
10 or 50 or 100 250 500 800 1000 3000 Yearly As req.
Service
Daily Weekly
Drive belts tension – initial
check
Initial
Track tension – initial check Initial
Engine oil level – check •
Cooling air duct screen –
check/clean
•
Air cleaner element – clean • •
General grease points
(see
section in manual “ General grease
points ” or weekly service checks
label on housing wall)
•
Knives – check, sharpen or
replace
• •
Drive belts tension -
check/adjust
•
Hydraulic pump belt tension -
check/adjust
•
Track gearbox oil – initial
change
Initial
Hydraulic system – check •
Engine fan belt – check •
Engine oil & filter – change • •
Hydraulic oil filter - replace •
Battery electrolyte level &
terminals - check
•
Engine fuel filter – replace •
Outlet chute – remove & clean
swivel
•
Feed roller tension springs -
replace
• •
Anvil – check knife clearance
and bolt torque
• •
Hydraulic filter – replace •
Grease engine output shaft –
Hayes coupling
•
Air cleaner element – replace •
Feed roller teeth – sharpen • •
Track gearbox oil - replace •
Hydraulic oil – replace •
Engine fan belt - replace •
Engine – Valve clearances (refer
to Deutz service manual)
•
Engine – 3000-hour service by
authorised Deutz specialist
(refer to Deutz service manual) •
Nuts & bolts – check torque &
replace if worn
•
Battery – replace •
Drive belts – replace •
Hydraulic pump belt – replace •
Knives – replace •
Anvil – replace •
Hazard labels – replace •
Rubber tracks - replace •