Hansa C65RX O&M Manual
–
OM-029 First Release 4/05/2021
© Hansa Chippers 2021
27
Grease points
General grease points
The grease points listed below must be greased every 50 operating hours with bearing grease or all-purpose grease:
1.
Two bearings on the cutting rotor shaft, one
on the front side of the housing, and one on
the rear:
2.
One bearing on the right-hand side of the
feed roller
3.
Two bearings on either side of the feed roller
pivot
(also referred to as “swing arm”):
1
2
3
4
5
6
