Hanlong Technology Co., Ltd Unicorn 60x0 User Manual Page 5 of 25
Firmware
1.0.0.29 Last Updated 8/2010
TABLE 1: Definitions Of The Unicorn Connectors
LAN (or PC)
Connect your PC to this port. It will then be assigned an
IP address from your Router/DHCP Server. The
Unicorn 60x0 acts as a switch only.
WAN (or LAN)
Connect to the internal LAN network or Public Internet.
RESET
Factory Reset button. Press for 7 seconds to reset
factory default settings.
POWER IN
Power adapter connection
FXO1 - FXO8
FXO ports to be connected to physical PSTN lines from
a traditional PSTN PBX or PSTN Central Office.
Figure 2: Diagram Of Unicorn 60x0 Display Panel
TABLE 2: Definitions Of The Unicorn Display Panel
Power LED
Indicates Power.
Remains ON when Power is connected and turned ON.
Ready LED
Remains ON after boot-up.
LAN LED
Indicates LAN (or WAN) port activity
WAN LED
Indicates PC (or LAN) port activity
LEDs 1 - 8
Indicate status of the respective FXO Ports on the back
panel
Busy - ON
Available - OFF.
NOTE:
All LEDs display green when ON.
During a firmware upgrade or configuration download the following LED pattern will be
observed:
Power, WAN LEDs will be ON. The RUN LED will keep flashing during download and
while the new files are written. The entire process may take between 5 to 15 minutes. The
