Hanlong Technology Co., Ltd Unicorn 60x0 User Manual Page 25 of 25
Firmware
1.0.0.29 Last Updated 8/2010
7 RESTORE FACTORY DEFAULT SETTINGS
There are two (2) methods for resetting your unit:
Reset Button
Reset default factory settings following these four (4) steps:
1. Unplug the Ethernet cable.
2. Locate a needle-sized hole on the back panel of the gateway unit next to the power
connection.
3. Insert a pin in this hole, and press for about 8 seconds.
4. Take out the pin. All unit settings are restored to factory settings.
IVR Command
Reset default factory settings using the IVR Prompt (Table 5):
1. Dial “***” for voice prompt.
2. Enter “99” and wait for “reset” voice prompt.
3. Enter 862584658050
NOTE:
1. Factory Reset will be disabled if the
“Lock keypad update”
is set to “Yes”.
2. Please be aware by default the Unicorn 60x0 WAN side HTTP access is disabled. After
a factory reset, the device’s web configuration page can be accessed only from its LAN
port.
8 TECHNICAL SUPPORT CONTACT
Email:
