HANGCHA CPD10-A, Руководство по эксплуатации и обслуживанию

Страница: 50 / 82

46
stop the truck.
–
Place the shift lever in neutral.
–
Pull up the parking brake lever.
– Down the forks on the ground, tilt mast
forwards fully.
–
Place the key switch in “OFF” to shut off
the battery. Remove the key and keep it.
CAUTION
 Don’t dismount from the moving
truck, never jump from the truck.
 Don’t parking the truck on the
working road.
Loading
–
The forks should be adjusted properly to
maintain the balance of load.
– Place the truck right in front of the load to
be handled.
– The pallet should be evenly positioned
across both forks.
–
Insert forks into the pallet as far as
possible.
– To raise loads from the ground
：
–
Firstly, lift the forks 5 to 10 cm off the
ground or floor and make sure loads lay
stably.
– Then tilt the mast backwards fully and lift
forks up to 15 to 20 cm off ground then
start running.
–
When handling bulky loads which restrict
your vision, operate the truck in reverse
except when climbing grades.
Stacking load
– When approaching the deposit area slow
down your truck.
– Stop the truck right 30 cm far away from
the position where your load is to be
deposited.
– Check the condition of the deposit area.
– Tilt the mast forward until forks become to
horizontal. Raise forks until they are a little
higher than the deposit position.
–
Move forward to place the load directly
over the desired area and stop the truck.
– Make sure your load is just over the
desired area. Slowly lower the load into
position. Make sure the load is securely
stacked.
–
Do necessary lift-tilt operations and then
back away to make the forks leave loads.