HANGCHA CPD10-A, Руководство по эксплуатации и обслуживанию

Страница: 49 / 82

45
10. Driving and Operation
WARNING

Before operating the truck, check all
controls and warning devices for
proper operation. If any damage or
fault is found, don’t operate truck
until corrected.
Driving
–
Open the cap, and insert the storage
battery plug, then close the cap.
–
Set the direction switch to neutral
position .
– Turn on key switch .
– Hold the steering wheel with left hand and
turn on the key switch with right hand.
– Tilt back the mast
–
Control the lifting lever to set the bottom of
the fork 150-200mm above the ground.
Control the tilting lever to fully tilt back the
mast.
– Control direction lever.
– Forward
：
Push the direction lever forward.
–
Backward
：
Pull the direction lever
backward.
–
Loosen the hand brake lever
– Step the brake pedal and push the hand
brake lever to the front position.
– Hold the steering wheel with your left
hand and attach your right hand.
Traveling
Step the accelerate pedal slowly, the truck will
travel forward or backward.
Decrease speed
Loosen the accelerate pedal slowly, the
truck will decelerate.
CAUTION
Decelerate the truck in the situations
following:

Turning;

Close the goods or pallet;

Close the deposit area;

Enter a narrow passage
；

The condition of road surface is
bad.
WARNING
 Don’t step the accelerate pedal and
brake pedal at the same time.
Turning
Unlike general passenger-cars, the turning
wheels are located at the rear of the truck.
This cause the counterbalance swing out
when turning.
Slow down the truck and turn the steering
wheel toward the side which you are turning.
The steering wheel should be turned a bit
earlier than as with the front wheel steering
car.
CAUTION

Drive the truck slowly and control
the steering wheel carefully, assure
there is enough space to steer.
Stopping or parking
– Slow down and press the brake pedal to