Hangar 9 ULTRA aspire, Инструкция по эксплуатации

Страница: 25 / 40

25
Section 9: Installing The Canopy
• Fuselage
• Canopy
• Small rubber band (1)
• Plywood canopy braces (2) • 6-minute epoxy • Medium sandpaper
• Epoxy brush • Scissors
• Rubbing alcohol • Pencil
• Paper towels • Masking tape
Parts Needed Tools and Adhesives Needed
Step 1. Locate the plywood canopy pieces and the canopy
Step 2. Look at the canopy and note the scribe markings on it.
This is your guide to cutting out the canopy. Carefully cut out
the canopy using sharp scissors. Be sure to cut along the out-
side of the scribe markings as carefully as possible.
Step 3. Trial fit the canopy on the front of the fuselage. The
sides of the canopy should extend onto the fuselage sides and
cover the opening. There are two pieces of plywood that must be
epoxied to the canopy. The larger piece holds the canopy on the
fuselage using the small rubber band provided.
Step 4. The forward plywood brace is located 1 /
2
“ from the
small end of the canopy.
Step 5. The larger plywood brace, used to attach the rubber
band, is located 6 1 /
2
” from the front end (small end) of the
canopy and up 1 /
4
” on either side of the canopy.