Hangar 9 ULTRA aspire, Инструкция по эксплуатации

Страница: 13 / 40

13
Section 3: Installing the Tail
Step 10. With the fuselage resting on a flat surface and the
horizontal stabilizer attached to the fuselage, adjust the stabilizer
until you have an equal distance on both the right and left sides
of the stabilizer to the wing. When you are satisfied they are
even, tape the horizontal stabilizer securely in place and allow
the epoxy to cure. Check once more to make sure the slots of
the horizontal stabilizer and fuselage are aligned. This is to make
sure that when the vertical stabilizer/rudder is inserted, it will be
properly aligned to the centerline of the fuselage. Use rubbing
alcohol and a paper towel to remove any excess epoxy.
Note: Use masking tape to hold in place until epoxy is cured.
Step 11. Mix up approximately 1 ounce of 30-minute epoxy
and apply it to the bare wood areas of the vertical stabilizer.
Carefully insert the vertical stabilizer into the slot provided in the
fuselage/horizontal stabilizer. Wipe away any excess epoxy with
rubbing alcohol and a paper towel. Check the alignment so
the rudder has just a slight gap between it and the horizontal
stabilizer (see below). A 90-degree triangle can be used to check
the alignment of the vertical stabilizer to the horizontal stabilizer.
Use masking tape to hold it in position until the epoxy cures.
CONTINUED