Hangar 9 ULTRA aspire, Инструкция по эксплуатации

Страница: 16 / 40

16
Step 11. Remove the horn and using a 1 /
16
” drill bit, drill the
holes for the elevator control horn screws in the elevator.
Step 12. The rudder control horn will be centered 3 /
8
” up from
the bottom of the rudder, positioned so the pushrod wire holes
on the horn line up over the hinge line of the rudder/
vertical stabilizer. When you’re satisfied with the position,
mark the screw hole locations on the rudder using a felt tipped
pen or pencil.
Step 13. Remove the control horn and drill the screw hole
locations with a 1/16” drill bit.
Step 14. Attach the elevator and rudder control horns using
the four 8mm screws and a medium Phillips screwdriver. Use
care not to slip and damage the covering.
Section 4: Hinging the Rudder and Elevator
CONTINUED