Hangar 9 ULTRA aspire, Инструкция по эксплуатации

Страница: 18 / 40

18
Section 5: Installing The Radio
Step 6. Attach the appropriate servo leads to the receiver.
Install the receiver just in front of the servos. (Refer to
photo below).
Step 7. The antenna lead will be run from the bottom of the
fuselage area out to the opening in the fuselage tail.
Step 8. Use radio packing foam (available at your local hobby
shop) to hold the receiver and the battery in place in the fuse-
lage. This also provides some shock support during landings.
Step 9. Before attaching the battery pack to the fuselage with
servo tape, be sure to balance the aircraft first. Balance can be
adjusted by moving the battery back and forth in the fuselage
nose to achieve balance. Always try this first before adding any
weight to the aircraft. See Section 10, Balancing the Aspire, for
more information
Step 10. A switch can be installed in the side of the fuselage
under the wing.
Step 11. With the servos hooked into the receiver and the
battery connected, turn on your transmitter. The servos will
center. Make sure the trims on your transmitter are centered.
Turn off the receiver and then turn off your transmitter. The ser-
vos are now in their electrical “center” position. The servo horns
can now be installed on the servos as shown below.
CONTINUED