Hangar 9 EDGE 540, Инструкция по эксплуатации

Страница: 8 / 59

8
Sealing the Hinge Gaps (continued)
Step 11. Using a sharp #11 blade and a straight edge, carefully
cut through both layers of UltraCote
®
covering at the
3
/
8
'' point
marked in Step 2.
Step 12. Mark and cut the folded covering to an overall length
of 25
5
/
6
''. This piece will be inserted and ironed down into the
hinge bevel on the bottom of the aileron.
Step 13. Remove the backing from the UltraCote
®
. Place the
folded crease side into the center of the hinge line on the bottom
of the wing. Using a straight edge as shown, hold one side of the
overing in place while ironing down theopposite side with a
sealing iron. We recommend setting the iron temperature to
320° for this operation.
Step 14. Fully deflect the aileron in the up position. Place the
straight edge over the hinge line covering that you just ironed
down in Step 5 with the edge of the straight edge placed firmly at
the bottom of the hinge line as shown. Iron down this side of the
covering, making sure the aileron is fully deflected.
Section 1: Hinging the Ailerons
CONTINUED