Hangar 9 Advance 40, Инструкция по эксплуатации

Страница: 18 / 36

18
Important Safety Note: The wing nuts must be tightened
to the position shown below on the horizontal tail so
they clear the fuselage when installed.
Step 2. Trial fit the tail assembly into the tail of the fuselage as
shown by sliding forward the tongue of the vertical fin into the
fuselage.
Step 3. Remove the tail assembly. There are two screw holes on
the rear plate. Put a washer on the screw and install the front
screw in the plate, through the hole on the bottom of the
fuselage. Apply a drop of thread lock to the screw. Fit the tail
back into place. Slightly secure the screw to the tail. Hold the
screw in place with the screwdriver to keep the screw from being
pushed back into the fuselage when installing the tail.
Hint: Sit the fuselage on a table with the rear extending off the
end. This way you can help guide the screws into the fuselage
through the opening of the tail saddle.
CONTINUED
Stage 4—Installing the Tail
Now take the second screw, apply a drop of thread lock and
insert it from the bottom, through the fuselage and into the tail
assembly.
Note: A washer is not required for the rearward tail
attachment screw.
By not fully tightening the first screw you can move the tail to
help align it for the second screw. Patience pays off here. Once
aligned, securely tighten both screws.
Step 4. After you’ve completed the installation of the tail, the
opening can be covered with the red vinyl covering provided.
45°