Handicare MINIVATOR 2000, Руководство по установке

Страница: 12 / 52

12 MINIVATOR 2000 INSTALLATION MANUAL
Power pack
Loading the power pack
Items required: Tools required:
• Power pack • Loading toggle
• Shorting links
• Loading bars
1 Take off the front cover from the power unit
(Figure 25) .
Power footplate only
Note:
Do not force the footplate down
– you will damage the actuator.
a Protruding from the top of the power pack
is a black and a red set of leads (Figure 26) .
Connect these to the 9V remote handset
battery to lower the footplate, giving access
to the panel. If the footplate does not lower
reverse the connections.
2 Fit the power pack loading bars to the top of
the track (Figure 27) .
3 Feed the power pack on to the loading bars
(Figure 28) .
4
Refit the batteries.
5 Connect the dummy seat toggle looms:
a Driving toggle 8 way connector (Part No.
181001.50083) and conversion loom
(SIM22900) – seat, direction, key switch
and swivel (can only be fitted one way)
(Figure 29) .
b 2.5mm battery link (Part No. 181001.52036)
across the flying battery leads – red link wire
(Figure 30) .
Note: Ensure that this connection is not
earthed as it will blow a fuse.
6 Taking care not to damage the charge contacts,
drive the power pack on to the track using the
driving toggle.
Note: Ensure that the top and bottom trunnions
are correctly engaged to the corresponding
teeth on the top and bottom track
(Figure 31)
.
NOTE: IF THE POWER PACK IS
LOADED WITHOUT CORRESPONDING
ENGAGEMENT OF THE TOP AND
BOTTOM TRUNNIONS; AND THE POWER
PACK IS OPERATED IT WILL CAUSE
PERMANENT DAMAGE TO THE POWER
PACK. FIGURE 32 SHOWS HOW AN
INCORRECTLY LOADED POWER
PACK WILL APPEAR.
If this occurs a new power pack MUST
be ordered as a matter of safety.
Figure 25
Figure 26