Handicare MINIVATOR 2000, Руководство по установке

Страница: 10 / 52

Electrical connections
10 MINIVATOR 2000 INSTALLATION MANUAL
5 At the end of the track that you will be
connecting the power supply to continue
the installation as follows:
a Remove the paint from the stanchion and
rail (Figures 17 and 18) .
b Connect the negative charge connection
loom to the track (Figures 19 and 20) .
c Feed the cable from the charge contact
through the hole at the rear of the positive
charge contact into the stanchion
(Figure 19) .
d Feed the end of the negative charge
connection loom through the same hole
and out of the stanchion.
e Drill hole and then run the power supply
lead into the back of the stanchion foot and
out of the top of the stanchion
(Figure 21) .
f Connect the power supply to the two way
connecting block
(Figure 22)
. Red to white
and black to black.
g Insulate the two way connecting block
with electrical installation tape and carefully
insert the block into the track
(Figure 23) .
h
Repeat step f above at the other end of the
track.
i Replace the end cap at the BOTTOM OF
THE STAIRS ONLY (Figure 24) .
6 Fit the remaining bolts in to the top and
bottom track sections for the first and last
stanchion.
7 Fit the power supply to the wall using the
supplied bracket.
8 Terminate the power supply to the available
AC supply.
Note: All mains wiring must comply with the
local standards in force at the time of installation.
Do not fix the power supply to the stringer.
Figure 17
Figure 18
Figure 19