handi quilter Infinity 26 QM33001, Руководство пользователя

Страница: 18 / 90

HQ Infinity User Manual
| 17
To adjust the hand-position angle of the front handlebars
Rotate the angle of the handlebars to a comfortable position by using the two levers below the handlebars.
ONLINE
: For more information about adjusting the position and angle of the front handlebars,
watch the video
Adjusting the Position and Angle of the Handlebars
at:
http://www.handiquilter.com/videos/hq-infinity/212/ .
• Loosen the levers by turning them counterclockwise. Then grasp the front of the handlebars and
adjust them inward or outward to a comfortable position for general quilting. Tighten the levers by
turning them clockwise when you are happy with the position.
To use the handlebars for micro quilting
ONLINE
: For more information about adjusting the position and angle of the front handlebars,
watch the video
Adjusting the Position and Angle of the Handlebars
at:
http://www.handiquilter.com/videos/hq-infinity/212/ .
ONLINE : For more information about micro quilting, watch the video
Micro Quilting
at:
http://www.handiquilter.com/videos/hq-infinity/239/
.
When micro quilting, you’ll want to have your hands (and therefore, handlebars) close to the quilt top.
In addition to adjusting the angle of the front handlebars, you can adjust how closely positioned the
handlebars are relative to the quilt.
• Use the 5mm hex tool to loosen the bolt at the back of the handlebars. Grasp the handlebars and
tilt them closer to the quilt until they are in a comfortable position for micro quilting. Then tighten
the bolt with the hex tool.
NOTE
: If you expect to regularly alternate between regular quilting and micro quilting, we
recommend that you replace the bottom bolt at the back of the front handlebars with the extra
lever bolt that was provided. Use the 5mm hex tool to loosen and then remove the bottom bolt
at the back of the handlebars. Screw in the extra lever bolt and finger tighten.
Configurable Handlebar Buttons
The Infinity handlebars are configurable so you can decide which functions you want the left and right
handlebar buttons to do when pressed. Once configured, the front and back handlebars work the same.
The machine comes from the Handi Quilter factory configured to have the right handlebar control starting
and stopping quilting and increasing stitching speed in Manual mode or stitches per inch in Regulated
mode. The left handlebar controls cycling the needle up and down and slowing the stitching speed or
decreasing stitches per inch. However, you can switch the functions from one side to the other. You can
also select from several functions and assign one to the star button and another to the diamond button.
For example, choose to have the diamond button perform a bobbin-thread cut and the star button to
perform a tieoff.