GB
51
• The length of the hose between the check valve and high-pressure washer should be at least 10 metres
to dampen any pressure surges�
• The minimum hose dimension is 1/2” (13 mm)�
• The hose must be reinforced�
• The incoming water flow must be at least the same as the maximum flow for the machine�
• This high-pressure washer must only be connected to the municipal water conduit system if a suitable
check valve is installed�
WARNING:
The temperature of the inlet water must not be more than 60°C� The inlet pressure of the
water must not exceed 7 bar�
IMPORTANT:
Only use the machine with clean water� Unfiltered water, or water with corrosive chemicals,
can damage the machine�
Set the power switch in the OFF position�
• Check that the mains voltage corresponds to the rated voltage on the type plate�
• Plug in the power cord�
USE
• Never use the machine in explosive environments, for example, in the vicinity of flammable liquids,
gases or dust�
• Operating temperature: 0 to 40°C�
