GB
54
LOW PRESSURE MODE
The nozzle must be set at OUT-position for low pressure jets� Low pressure mode must always be used in
conjunction with cleaning agent�
1�
Turn the nozzle anticlockwise as far as it will go so that the distance between the nozzle and the
base is as large as possible�
2�
In low pressure mode, turn the top of the nozzle clockwise to fully open the nozzle�
Low pressure mode with cleaning agent
NB
The spray nozzle must be set at a narrow spray pattern, so that the metal blades at the very end of
the nozzle are fully open and the jets are not restricted�
1�
When used with cleaning agent, the container must be filled with the correct mixture of water and
cleaning agent according to the instructions on the container (Figure 6)� The container is supplied
with a hose which is fitted on the screw cap (Figure 7)�
–
To remove the cleaning agent container, first take off the cap and then pull the container
upward and outward with one finger�
2�
Dissolve dirt by applying cleaning agent with the jet set at a wide spray pattern against the dry
surface� Work from below and upward on vertical surfaces�
3�
Allow the cleaning agent to act for 1 to 2 minutes, but do not let it dry�
4�
Rinse off the cleaning agent from the surface from the bottom up
OUT-position
Narrow spray pattern
