5
Installation
1
B
2
Loosen the track mounting screws (A) preassembled to the
mounting plate (B).
Do not remove the track mounting screws (A) completely.
E
D
B
A
Field cutting the track to special lengths (Optional)
Separating the canopy
F
NOTE:
□
□
□
□
□
□
□
□
□
□
Remove all burrs, insulators, and copper bus bars from the
track.
Push the copper bus bars back into the insulators 3/8th in.
from the end of the insulators.
After you complete step 4, the bus bar insulators should be
a minimum of 3/8th in. and a maximum of ½ in. from each
end of the insulator. If this is not the case, make appropriate
Reinstall the dead end and/or appropriate feed connector,
and tighten the screw.
length of track that is 4 feet or less in length has one mounting
opening spaced a maximum of 6 in. from each track end
section. A single section of track that is greater than 4 feet
in length must have mounting openings a maximum of 12 in.
from each end of the track with additional openings a
minimum of every 4 feet along the length of the track section.
Additional openings every 4 feet along the track section may
be added as needed.
Remove the canopy screws (E) from the canopy (D) to
expose the mounting plate (B).
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
and bus bars even to end) to the desired length. Be sure to
reinstalled to the track end.
Cutting should be done preferably from the dead end of the track.
