2
Table of Contents
Safety Information
Table of Contents ..........................................
..........................................
2
Safety Information ........................................2
Warranty ...................................................
.......................................................
3
3
3
..........................................
.........................................
Tools required
3
Hardware Included
..........................................
4
Package Contents
Pre-Installation
..............................................
Installation
Operation
Care and Cleaning
8
8
8
5
Troubleshooting ..............................................
.............................................
IMPORTANT SAFETY INSTRUCTIONS
Do not install any part of this track system less than 7 feet
Do not install any lamps closer than 6 inches from any curtain
or similar combustible material.
This track system is not intended for use with a power supply
cord or convenience receptacle adaptor.
This track system must be supplied by a single branch
120 volt circuit.
The track is not intended to be pendant mounted such as by a
stem or cable.
The mounting screws are to be mounted along the track in the
keyhole slots provided.
Disconnect electrical power before adding to or changing the
□
□
□
□
□
□
□
□
□
□
SAVE THESE INSTRUCTIONS
Before energizing, make sure that the lighting system is clear
of all material which could cause a direct short, and check all
electrical connections to make sure they are secure.
Do not attempt to energize anything other than EC series track
tools, extension cords, appliances, etc. to the track.
Lamp gets hot quickly! Touch only the switch or plug when
turning on. Do not touch the hot lamp lens. Turn off power and
allow bulbs to cool down before replacing.
WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE
FOLLOWING:
WARNING
: Do not install this lighting system in a damp or
wet location.
IMPORTANT:
For use with Hampton Bay EC series line
voltage track systems only.
CAUTION:
Lighted lamp is hot!
CAUTION:
To reduce the risk of a burn during re-lamping,
remove from the track before re-lamping.
CAUTION:
Hot surface, keep away from curtains or
any other combustible material.
NOTE:
All electrical connections must be in accordance with
local codes and the National Electrical Code. If you are
unfamiliar with methods of installing electrical wiring, secure
CAUTION:
Do not touch lamp at any time. Use a soft cloth.
Oil from skin may damage lamp.
Read all instructions. Save these instructions and refer to them
made.
□
