Document #101-0086
60
5/22/07
PROGRAMMING THE HVX or XE VALIDATOR:
1.
With the power on, check the operation of the validator. A dot flashing
on the LED indicates it is operating normally.
2.
Note the position of each switch on the DIP switch. (The DIP switch is
located on the side of the validator.)
3.
Set all 10 DIP switches to the OFF position. Then, starting with switch
#10, slowly move the switches to the ON position, one switch at a time
and in descending order (10, 9, 8, 7…). The LED should now be
flashing the letter “P”. This signifies that the validator is in the To-
kenote® Programming Mode.
4.
At this point, it is recommended to insert the CLEAR ALL Training
Coupon, especially if this is the first time the validator is being pro-
grammed or if it has just been returned after being serviced. The
CLEAR ALL Coupon will erase all previously trained Tokenotes®
from the validator’s memory but will not affect the controller’s
memory.
5.
Insert one coded Tokenote® into the validator, making sure that it is
accepted.
6.
Repeat step 5 for each uniquely coded Tokenote® you wish to pro-
gram. (Make sure that each Tokenote® is equal in value.) Up to 14
different codes can be programmed.
7.
Starting with switch #1, slowly move the switches back to their origi-
nal positions one at a time. This must be done in ascending order (1, 2,
3, 4…). A dot should now be flashing on the LED. Switch #2 must be
in the OFF position in order to accept Tokenotes®.
PROGRAMMING THE CONTROLLER:
You must set the Tokenote® Value:
•
Push the top and bottom buttons on the ACW Controller simulta-
neously for about 3-5 seconds to enter the programming mode.
•
You must use the four wash select buttons and the refund button
located on the door. For ease of reference, the top blue button will be
#1. The second down will be #2, the third will be #3 and the bottom
will be known as #4.
•
Press the #2 button to scroll to the TOKENOTE VALUE? category.
•
Press the #4 button to enter the category.
•
Press the #2 button to scroll between the options:
TOKENOTE=
•
The amount can be set from $0.00 to $63.75.
•
Press the #2 button to increase the amount in $.25 increments.
•
Pressing the #3 button will decrease the amount in $.25 increments.
•
Press the #1 button to exit the category.
•
Press the #2 button to scroll to the next category.
