Technical Data Sheet
HBH550 – 220-240V
PROPRIETARY RIGHTS NOTICE
This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and
proprietary and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and
any information contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article
fabricated or assembled from this document without the prior written consent of HBB.
4421 Waterfront Drive
Glen Allen, VA 23060
Revision Description:
Corrected for clarification
Request Number:
DOC4244
Revision Date:
11/7/13
Approved by:
DOC4244
Issue Code(s):
L
Page:
8
of
8
Document #:
520006901
Rev:
C
ENG-FRM-RIC-4.32, Rev. E
Testing the Container for a Worn or Frozen Cutter Assembly
-
Remove the container from the blender base. Hold the container by the handle
and slowly turn the coupling at the bottom of the container. The cutter assembly
and drive coupling should turn freely without wobbling or difficulty.
How to Determine Cycle Count
-
Turn the power switch to off.
-
Unplug the machine.
-
Turn the machine upside down so that you can look into grid holes on the
bottom front right.
-
Plug the machine in and turn the power switch to the on position.
-
Count the number of flashes from the LED lights; first red, then yellow, then
green.
-
Example: Red- 2, Yellow- 0, Green- 8. You have recorded 208.
-
At the end add two zeros. Your cycle count = 20,800.
