Technical Data Sheet
HBH550 – 220-240V
PROPRIETARY RIGHTS NOTICE
This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and
proprietary and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and
any information contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article
fabricated or assembled from this document without the prior written consent of HBB.
4421 Waterfront Drive
Glen Allen, VA 23060
Revision Description:
Corrected for clarification
Request Number:
DOC4244
Revision Date:
11/7/13
Approved by:
DOC4244
Issue Code(s):
L
Page:
4
of
8
Document #:
520006901
Rev:
C
ENG-FRM-RIC-4.32, Rev. E
RFI Filter Wiring Details (See Figure 3.)
-
Black wire (top left) J4 from the top left terminal to terminal J1 on the Control
Board.
-
Blue wire (bottom left) J5 to terminal J2 on the Control Board.
-
White wire (top right) J3 splits to left terminal of cord socket plug and Reset
terminal of circuit breaker/On-Off switch.
-
Black wire (center right) J2 to center terminal of circuit breaker.
-
Yellow/Green striped wire (bottom right) J1 to motor chassis.
RFI Board Removal and Replacement
-
Disconnect wires from RFI board, mark if necessary or refer to wiring detail for
proper placement.
-
Remove the three Phillips screws and gently pull the RFI board off blender.
-
Replace with new board, and assemble in reverse order.
Figure 3. RFI FILTER
