Technical Data Sheet
HBH550 – 220-240V
PROPRIETARY RIGHTS NOTICE
This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and
proprietary and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and
any information contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article
fabricated or assembled from this document without the prior written consent of HBB.
4421 Waterfront Drive
Glen Allen, VA 23060
Revision Description:
Corrected for clarification
Request Number:
DOC4244
Revision Date:
11/7/13
Approved by:
DOC4244
Issue Code(s):
L
Page:
3
of
8
Document #:
520006901
Rev:
C
ENG-FRM-RIC-4.32, Rev. E
Motor Removal and Replacement
-
Disassemble upper housing as described in housing disassembly above.
-
Disconnect the motor leads from terminals J3 and J4 on the Control Board.
-
Remove the two screws securing the lower housing.
-
Remove the ground wire from motor chassis.
-
Lift the motor from the lower housing.
-
Assemble in reverse order.
Cord Socket and Circuit Breaker Wiring Details (See Figure 2.)
-
White wire from left terminal of cord socket splits to wire nut and routes to Reset
terminal
of circuit breaker/On-Off switch and to J3 on RFI board
-
Yellow/Green striped wire routes from center terminal of cord socket to the
motor chassis (ground).
-
Red wire routes from the right terminal of the cord socket to the Off terminal of
the circuit breaker.
-
Black wire routes from center terminal of circuit breaker to the RFI Board J2
terminal.
Figure 2. Interior View of Power Cord, Socket Cord and Circuit Breaker
