10
11
Select
Optain an IP address automatically
and
Optain
DNS server address automatically
, if there is a DHCP
server in your network. Confi rm by clicking
OK
, and
again in the subsequent window.
Your PC is now confi gured such that the router assigns the
IP address automatically.
If you do not have a device with an integrated DHCP
server, you must assign the IP addresses manually. The
following example describes basic setup using manual
address assignment. For local networks, special address
ranges are provided which are not transmitted over the
internet. As an example, a range that you can use for your
network is 192.168.1.1 to 192.168.1.254. The fi rst PC is
assigned the address 192.168.1.1, the second 192.168.1.2,
the third 192.168.1.3, etc.
Select
Use the following IP address
and enter your IP address
in accordance with the sample.
1.PC = IP address 192.168.1.1 Subnet mask 255.255.255.0
2.PC = IP address 192.168.1.2 Subnet mask 255.255.255.0
Click
Ok
to confi rm your entries.
5. Uninstalling the driver and confi guration program on Windows®
Switch off your PC and unplug the mains plug from the socket. Open the PC case. Remove the wireless
LAN PCI card from the PC and close the PC case again. Insert the mains plug in the socket again and start
the PC.
Select
Start => Settings => Control Panel => Software
To do so, select
Hama Wireless Utility
and click
Remove.
At the next prompt, click
Remove completely
.
Remove the device from your computer when prompted to do so. Afterwards click
OK.
The program is now deleted from your computer.
After the software is removed, you may have to restart the system. Save all open documents and close all
programs before restarting the PC.
6. Installing the driver and confi guration program on MAC OS X
Before installation, please save any open documents you may be working on. Then close all running
programs. Ensure that you have administrator authorisations to enable you to install the driver
correctly.
Connect the device to a free PCI slot. Then start your Apple computer.
After the operating system has loaded completely and the desktop is complete, insert the enclosed driver
CD-ROM in your drive. An icon with the CD-ROM then appears on your desktop. Double-click the icon and
select the MAC driver directory in the Finder window. This directory contains the DMG fi le required for
installation. Double click the
DMG fi le
to activate the image.
After you activate the image, select the correct directory for your installed MAC OS X Version and then
double click the corresponding
PKG fi le
. Installation is now started.
Select your hard drive on which you want to install the driver and the confi guration program. You must then
restart the system.
7. Confi guring the operating system and computer on MAC OS X
After you have installed the driver, you must confi gure the network environment in accordance with the
new situation. To do so, proceed as follows.
Click the
Apple
symbol in the upper menu bar and select
the
Location
menu item.
Select the
“Network”
setting menu item. The following
window opens. Click
OK
to confi rm the message.
Note:
If the message shown above is not displayed, the device was not correctly identifi ed by your Power-
Mac. Ensure that the device is connected properly!
After the Hama WLAN Adapter has been properly
detected, the following window opens.
Select the
New Location
… option under Location.
Name the new Location e.g. WLAN and click the
OK
button.
