97095C (Rev. E - 10/99)
PAGE 3
RC8*C RC12*C AND 14762 & 14700 CUP DISPENSER
1. Familiarize yourself with the RC Wallframe which should already be in place in the wall. If not, refer to the RC Wallframe Installation
Instructions before proceeding.
2. Determine location of rough plumbing. At this point, you should decide which style trap you plan to use. For easier installation, we
recommend the use of a swivel trap.
3. Install the basin (See Fig. 6). Hold the basin flush against the wall, positioning the top edge just above the upper edge of the wallframe.
Then slide the basin down slowly until it engages the hanger bracket. Be sure the basin is firmly engaged before releasing it.
4. Finish securing basin in place. Align the brackets at the bottom of the basin with the bracket on the frame. Fasten the brackets together
using screws and speednuts (provided with fountain).
5. Install tailpiece assembly. Slide the slip nut and gasket from the trap onto the tailpiece. Insert the tailpiece assembly into the trap and
align its other end with the drain hole in the basin. Place rubber gasket between the tailpiece assembly and the basin, then screw in the
drain plug from above. Tighten the drain plug. Tighten slip nut and swivel joint. Snap the strainer plate into the drain plug.
6. Install a service stop (not provided) on the supply water inlet line. Turn on supply water and flush thoroughly.
7. Install refrigeration unit. Slide refrigeration unit into the wallframe and position tight against left side and flush with the front edge of
wallframe. WARNING: Adequate space must be maintained behind the refrigeration unit for air circulation.
8. Water supply connections (See Fig 7 & 8)
A. RC8A Models Connect service stop to tube marked Water Inlet on remote chiller. Make connection from chiller Cold Water Outlet
tube to regulator valve assembly using the provided elbow and strainer.
B. RC12A Models Connect service stop to precooler/tailpiece assembly inlet tube. Connect precooler/tailpiece assembly outlet tube to
tube marked Water Inlet on remote chiller. Make connection from chiller Cold Water Outlet tube to regulator valve assembly using the
provided elbow and strainer.
9. GF Model Only. Connect glass filler line to outlet on tee located between strainer and regulator valve assembly. (See Fig. 7A & 8A)
10. Open service stop and operate push button to purge air. Check thoroughly for leaks.
11. Check stream height from bubbler. Stream height is factory set at 45 50 PSI. If supply pressure varies greatly from this, remove
items 17 & 18 and adjust screw on regulator (item 14). Clockwise adjustment will raise stream height and CCW adjustment will lower
stream height. For best adjustment, stream height should be approximately 1-1/2 (38mm) above the bubbler guard. (See Fig. 15)
12. Connect refrigeration unit to electrical supply and check for proper operation. WARNING: Adequate space must be maintained behind
the refrigeration unit for air circulation.
13. Attach regulator holder (item 13) to grill (item 3) with hex nut (item 16). Hold grill and engage angle on top edge of grill with lower edge
of basin. Swing bottom of grill into place against the wall and securing grill mounting screws (provided).
FIG. 6
INSTALLATION INSTRUCTIONS
FOR THE
RC MODELS DRINKING FOUNTAIN
(refrigerated and non-refrigerated)
