Hall Technologies 2/1/2024
Page 25 of 28
Command
Response
Description
REBOOT
If a valid command is used,
most likely there will be no
response unless there was a
command formatting error.
Reboot the device
HELP
Show the list of available
commands
HELP N
where N=command
Show description of command
specified
RELAY N N1
where N=1
N1= OPEN, CLOSE, TOGGLE
RELAY N N1<CR><LF>
Relay control
LEDBLUE N N1
where N=1~8
N1=0-100%
LEDBLUE N N1<CR><LF>
Individual button blue LED
brightness control
LEDRED N N1
where N=1~8
N1=0-100%
LEDRED N N1<CR><LF>
Individual button red LED
brightness control
LEDBLUES N
where N=0-100%
LEDBLUES N<CR><LF>
Set the brightness of all blue
LEDs
LEDREDS N
where N=0-100%
LEDREDS N<CR><LF>
Set the brightness of all red LEDs
LEDSHOW N
where N=ON/OFF/TOGGLE
LEDSHOW N<CR><LF>
LED demo mode
BACKLIGHT N
where N=0-100%
BACKLIGHT N<CR><LF>
Set the max brightness of all LEDs
KEY_PRESS N RELEASE
KEY_PRESS N RELEASE<CR><LF> Set the key press trigger type to
“Release”.
KEY_PRESS N HOLD
KEY_PRESS N HOLD<CR><LF>
Set the key press trigger type to
“Hold”.
MACRO RUN N
RUN MACRO[N]
EVENT.<CR><LF>
x
x
where x = the macro
commands
Run the specified macro
(button).
The response also occurs if a
button is pressed.
MACRO STOP
MACRO STOP<CR><LF>
Stop all the running macros
MACRO STOP N
N=1~32
MACRO STOP N<CR><LF>
Stop the specified macro.