Halcyon TRAVELER, Руководство пользователя

Страница: 19 / 36

1. Open the large Velcro tab which is positioned at the enD
of the shoulder pad. Thread this tab between the harness
and the backplate slot. The Velcro should be facing up
and run through the same backplate slot as the harness.
Secure the large Velcro tab. The end of the pad should be
attached to the plate.
2. Position the harness strap above the shoulder pad and
line up the small vinyl tabs so they fit appropriately while
allowing room for the D-ring and providing a secure at-
tachment for bottom of the pad.
3. We recommended you fold the “loop” (softer part of
the Velcro) side of the Velcro in half to create a smooth
surface which simplifies insertion of the tabs through the
slot on the shoulder pad. Do not force the vinyl tab
through the slots in the shoulder pad.
4. You can place the Velcro tabs along any of the
slots in the shoulder pad but you should verify
the pad is secured evenly with the D-ring and ac-
cessory attachments (EPDMbands for Scouts, etc.) in
their proper position.
To Install the Backplate Pad:
1.
Secure the top two holes on each side of the plate by
inserting the nut in the hole on the face of the back-
plate. Wrap the tab of the pad around the plate and secure the bolt by screwing into the
nut that rests in the backplate mounting hole.
2. Repeat step one for the top two holes on each side of the backplate.
3. The third set of bolts is usually attached by folding the tab under the pad so it sits on
the face of the backplate. This provides additional room for lift devices. If you are not
using lift devices you may use the same method as detailed in step one. If you are using
the storage pocket in the pad the nut is sandwiched between the tab and the pad and is
aligned with the third backplate hole. The bolt runs from the back side of the plate and
attaches to the nut. This is also the recommended method of attachment if you will be
using a Cinch Quick-adjust harness.
4. The final bottom bolts (at the bottom of the plate) should be left undone if using the
backplate Storage pak. If you will not be using the Storage Pak you can attach the bottom
tabs.
5. Be sure you check your bolts are securely fastened. It is recommended to check the tight-
ness of your bolts regularly, particularly for the first few dives after assembly.
Figure 32
Figure 33
19
HALCYON.NET