Halcyon TRAVELER, Руководство пользователя

Страница: 10 / 36

hindrance or cause excessive drag.
The rear crotch D-ring is generally used for storing gear not used very often, such as reels or lift
bags. This D-ring needs to be low enough that you can clip/unclip gear (and not be blocked by
the bottom of the tanks), yet high enough that the gear does not hang down too far. Typically,
position the rear D-ring one hand-width down from the bottom of the backplate (figure 3 below).
The front crotch D-ring is only used with a tow-behind scooter. Gear should never be clipped to
this D-ring, as it will hang in the slipstream and pose significant entanglement hazards.
FINAL ASSEMBLY OF YOUR BC SYSTEM
Final assembly includes attaching the Halcyon Single Tank Adapter (STA) to the wing and
backplate with the two supplied fasteners/bolts. If you are using the 6-lb. Convertible Weight,
be sure this is in position in the STA (figure 4 above) and be sure the straps are correctly config-
ured on the STA. Place the wing on top of the STA through the bolts, then the backplate on top
of the wing. Tighten both bolts and fasteners securely. Slide the cam straps over your cylinder
and tighten at desired position in relation to the cylinder’s valve (figure 5 above). When div-
ing with doubles, the backplate is bolted to the cylinders with an Explorer or Evolve buoyancy
wing sandwiched between the backplate and cylinders. The bolts on the cylinder bands thread
through the two grommets on the wing (see images on the following page).
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5
10
HALCYON.NET